LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2005 >> Crossfire Base, 2D Convertible >> Repair and Diagnosis >> Suspension >> Wheel Alignment >> Suspension System >> Rear Suspension >> Trailing Link >> Installation

Trailing Link: Installation

Fig 1: Locating Trailing Link Bolts
GC0033659Courtesy of DAIMLERCHRYSLER CORP.
  1. Install the trailing link onto the vehicle.
    CAUTION: Vehicle must be at normal ride height before tightening components to specified torque.
  2. Install the outer trailing link bolt (2) attaching the trailing link to the wheel carrier.
  3. Install the inner trailing link bolt (1) attaching the trailing link to the rear axle carrier.
  4. Install the wheel and tire assembly.
  5. Lower the vehicle so it is not being supported by the lift.
  6. Tighten the outer trailing link bolt attaching the trailing link to the wheel carrier to 70 N.m (52 ft. lbs.).
  7. Tighten the inner trailing link bolt attaching the trailing link to the rear axle carrier to 70 N.m (52 ft. lbs.).
  8. Check vehicle alignment. (Refer to SUSPENSION/WHEEL ALIGNMENT - STANDARD PROCEDURE) .
scientia non olet · About LEMON Manuals