LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2005 >> Crossfire Base, 2D Convertible >> Repair and Diagnosis >> Suspension >> Wheel Alignment >> Suspension System >> Rear Suspension >> Track Bar >> Installation

Track Bar: Installation

Fig 1: Locating Track Bar Bolts
GC0033661Courtesy of DAIMLERCHRYSLER CORP.
  1. Install the track bar onto the vehicle.
    CAUTION: Vehicle must be at normal ride height before tightening components to specified torque.
  2. Install the outer track bar bolt attaching the track bar to the wheel carrier.
  3. Install the inner track bar bolt attaching the track bar to the rear axle carrier.
  4. Install the wheel and tire assembly.
  5. Lower the vehicle so it is not being supported by the lift.
  6. Tighten the outer track bar bolt attaching the track bar to the wheel carrier to 70 N.m (52 ft. lbs.).
  7. Tighten the inner track bar bolt attaching the track bar to the rear axle carrier to 70 N.m (52 ft. lbs.).
  8. Check vehicle alignment. (Refer to SUSPENSION/WHEEL ALIGNMENT - STANDARD PROCEDURE) .
scientia non olet · About LEMON Manuals