LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2005 >> Crossfire Base, 2D Convertible >> Repair and Diagnosis >> Suspension >> Wheel Alignment >> Suspension System >> Rear Suspension >> Camber Strut >> Installation

Camber Strut: Installation

Fig 1: Locating Camber Strut Bolts
GC0033658Courtesy of DAIMLERCHRYSLER CORP.
CAUTION: Vehicle must be at normal ride height before tightening components to specified torque.
  1. Install the camber strut onto the vehicle.
  2. Install the outer camber strut bolt attaching the camber strut to the wheel carrier.
  3. Install the inner camber strut bolt attaching the camber strut to the rear axle carrier.
  4. Install the wheel and tire assembly.
  5. Lower the vehicle so it is not being supported by the lift.
  6. Tighten the outer camber strut bolt attaching the camber strut to the wheel carrier to 70 N.m (52 ft. lbs.).
  7. Tighten the inner camber strut bolt attaching the camber strut to the rear axle carrier to 70 N.m (52 ft. lbs.).
  8. Check vehicle alignment. (Refer to SUSPENSION/WHEEL ALIGNMENT - STANDARD PROCEDURE) .
scientia non olet · About LEMON Manuals