Front Suspension: Knuckle: Removal: Inspection

Fig 1: Locating Ball Joint Stud Nut At Steering Knuckle

Courtesy of DAIMLERCHRYSLER CORP.

1. Check the lower control arm supporting ball joint by performing the following:
2. Remove the nuts (1) from the lower control arm supporting ball joint.
3. Using Special Tool 9168 Ball Joint Puller (2) press out the lower control arm supporting ball joint (1).
4. Check the lower control arm supporting ball joint. It should be possible to move the ball pivot without any play, binding, or creaking noises. Move the ball pivot in all directions with a tube approximately 6 in. (150 mm) in length. Check the boot for any cracks or damage. If the boot is leaking, replace supporting or follower joint.
5. Measure the steering knuckle, if necessary.