LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2005 >> 300 Base >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (3.5L Engine (Service Information)) >> Engine Mounting >> Mount - Right >> Removal

Mount - Right: Removal

WARNING: This page is about a different variant/trim than selected.
Fig 1: RIGHT ENGINE MOUNT HEAT SHIELD
GC0015432Courtesy of DAIMLERCHRYSLER CORP.
1 - BOLT
2 - SHIELD
3 - RIGHT ENGINE MOUNT
  1. Disconnect the negative battery cable.
  2. Raise and support the vehicle.
  3. Remove both of the engine mount to cradle nuts.
  4. Remove both of the engine mount through studs.
  5. Using a suitable jack stand and a block of wood positioned under the oil pan, raise the engine until the weight is off of the mounts (approximately 5 mm.).
  6. Remove the right mount heat shield (2) bolts. See Fig 1.
    Fig 2: RIGHT ENGINE MOUNT
    GC0015431Courtesy of DAIMLERCHRYSLER CORP.
    1 - BOLT
    2 - RIGHT ENGINE MOUNT
  7. Remove the engine mount (2). See Fig 2.
scientia non olet · About LEMON Manuals