Tie Rod End: Installation

WARNING: This page is about a different car, the 2004 Dodge Pickup and 2004 Dodge Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

Install tie rod to the left steering knuckle and drag link. Install the nuts and tighten to 108 N.m (80 ft. lbs.).
Remove the supports and lower the vehicle to the surface. Center steering wheel and adjust toe, (Refer to SPECIFICATIONS & PROCEDURES ).
After adjustment tighten tie rod adjustment sleeve clamp bolts to 61 N.m (45 ft. lbs.).

NOTE: Position the clamp on the sleeve so retaining bolt is located on the bottom side of the sleeve.