LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2005 >> 300 Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 99 (Power Steering System) >> Reservoir >> Installation

Section 99 (Power Steering System): Reservoir: Installation

WARNING: This page is about a different car, the 2004 Dodge Pickup and 2004 Dodge Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the reservoir bracket to the pump housing. DO NOT reuse the O-rings (install new O-rings).  Tighten bolts to 7 N.m (62 in. lbs.).
    NOTE: Ensure the reservoir is fully seated onto the pump.
  2. Install the reservoir to the bracket/pump body.
  3. Install the reservoir mounting bolts. Tighten bolts to 13 N.m (120 in. lbs.).
  4. Install the power steering pump. (Refer to PUMP ).
  5. Install the serpentine drive belt.
  6. Fill the power steering pump, (Refer to STANDARD PROCEDURE ).


  1. Lubricate new O-ring Seal with clean ATF+4 fluid or equivalent.
  2. Install O-ring seal in housing.
  3. Install reservoir onto housing.
  4. Slide and tap in NEW reservoir retainer clips making sure each tab locks into place on housing.
  5. Install power steering pump on vehicle. (Refer to INSTALLATION ).
  6. Fill power steering pump reservoir to correct fluid level. (Refer to STANDARD PROCEDURE ).
scientia non olet · About LEMON Manuals