LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2005 >> 300 Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 56 (Adjustable Pedals System) >> Removal & Installation >> Pedal Position Sensor >> Installation

Pedal Position Sensor: Installation

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2003 Dodge Grand Caravan, 2003 Dodge Caravan, 2003 Chrysler Town & Country, 2002 Dodge Grand Caravan, and 2002 Dodge Caravan. However, it is still accessible from the selected car via links, so may be relevant.
  1. Connect wiring connector to pedal position sensor.
    2. NOTE: Make sure pin in pedal assembly fits into slot in sensor carriage when installing sensor.
  2. Place sensor against mounting bracket and into brake pedal. Move carriage as necessary to align slot with pin. Install 2 mounting screws. Tighten screws to 66 INCH lbs. (7.5 N.m).
  3. Align the bulkhead connector mounting slot with its bracket and install it, locking it in place.
  4. Install silencer panel below lower steering column cover.
  5. Connect ground cable to negative post of battery.
  6. Connect scan tool (DRB-III(R)) to data link diagnostic connector located below steering column.
  7. Turn ignition key to ON position.
  8. Using scan tool, check for and clear any existing adjustable pedal fault codes.
  9. Test operation of adjustable pedals, memory sets (if equipped), and RKE (if equipped). If applicable, reset radio and clock.
  10. Recheck for any fault codes.
  11. Turn key to OFF position and remove scan tool from vehicle.
  12. Road test the vehicle to ensure proper operation of the adjustable brake system.
scientia non olet · About LEMON Manuals