LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2005 >> 300 Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 376 (Fuel System) >> Fuel Delivery >> Tank-Fuel >> Installation

Fuel Delivery: Tank-Fuel: Installation

WARNING: This page is about a different car, the 2005 Dodge Durango. However, it is still accessible from the selected car via links, so may be relevant.
  1. If fuel tank is to be replaced, install fuel pump module into tank. Refer to MODULE-FUEL PUMP  Removal/Installation procedures.
  2. Position fuel tank to hydraulic jack.
  3. Raise tank until positioned near body.
  4. Connect EVAP, ORVR and NVLD lines at front of tank.
  5. Connect fuel pump module electrical connector at top of tank.
  6. Connect fuel line quick-connect fitting to pump module.
  7. Continue raising tank until positioned snug to body.
  8. Install and position both tank support straps. Install two fuel tank strap bolts and tighten. Refer to TORQUE - FUEL SYSTEM .
  9. Connect rubber fill and vent hoses to fuel tank fittings and tighten hose clamps.
  10. If equipped, install fuel tank skid plate.
  11. Lower vehicle.
  12. Fill fuel tank with fuel.
  13. Start engine and check for fuel leaks near top of module.
scientia non olet · About LEMON Manuals