LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2005 >> 300 Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 150 (Exterior) >> Front Fender >> Installation

Front Fender: Installation

WARNING: This page is about a different car, the 2004 Dodge Pickup and 2004 Dodge Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the three bolts along the upper fender rail and tighten to 9 N.m (80 in. lbs.).
  2. Install the upper hinge support bolt at the cowl and tighten to 17 N.m (13 ft. lbs.).
  3. Install the two bolts below the headlamp and tighten to 9 N.m (80 in. lbs.).
  4. Install the inside and lower bolts and tighten to 17 N.m (13 ft. lbs.).
  5. Check the fender positioning and adjust as required by adding shims. (Refer to GAP AND FLUSH )
  6. Install the wheelhouse splash shield. (Refer to INSTALLATION  )
  7. Install the headlamp unit. (Refer to HEADLAMP UNIT )
  8. Install the cowl grille. (Refer to INSTALLATION  )
  9. Install the battery tray, if required. (Refer to BATTERY TRAY )
  10. Install the antenna, if required. (Refer to ANTENNA BODY & CABLE )
scientia non olet · About LEMON Manuals