LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2005 >> 300 Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 125 (Ignition Control) >> Knock Sensor >> Installation >> 5.7L V-8

5.7L V-8

WARNING: This page is about a different car, the 2004 Dodge Pickup and 2004 Dodge Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Thoroughly clean knock sensor mounting hole.
  2. Install sensor into cylinder block.
    NOTE: Over or under tightening the sensor mounting bolts will affect knock sensor performance, possibly causing improper spark control. Always use the specified torque when installing the knock sensors. The torque for the knock sensor bolt is relatively light for an 8mm bolt.
    NOTE: Note foam strip on bolt threads. This foam is used only to retain the bolts to sensors for plant assembly. It is not used as a sealant. Do not apply any adhesive, sealant or thread locking compound to these bolts.
  3. Install and tighten mounting bolt. Refer to TORQUE .
  4. Install electrical connector to sensor.
scientia non olet · About LEMON Manuals