Module-Antilock Brake: Installation

Fig 1: ABM REMOVAL/INSTALLATION

Courtesy of DAIMLERCHRYSLER CORP.

Align ABM solenoids and pump/motor wiring connector (4) with HCU valves (2) and connector passage. Slide ABM (1) onto HCU (3).

Fig 2: ABM ATTACHING SCREWS
Courtesy of DAIMLERCHRYSLER CORP.
Install three screws (2) attaching ABM (1) to HCU. Tighten screws to 2 N.m (17 in. lbs.) torque.

Fig 3: ICU AND BRAKE TUBES
Courtesy of DAIMLERCHRYSLER CORP.
Position assembly (5) above mounting grommets (8) and press mounting bracket into place.
Clip brake tube (3) to routing clip (4) below Fuse And Relay Center.
Clip brake tubes (1, 2 and 10) to two routing clips (6) along upper radiator support.

Fig 4: REAR TUBES AND CONNECTOR AT ICU
Courtesy of DAIMLERCHRYSLER CORP.
Connect 47-way wiring connector (5) at ABM (6).

Fig 5: LX BATTERY AND CABLES
Courtesy of DAIMLERCHRYSLER CORP.
Connect battery negative cable (2) to battery post. It is important that this is performed properly. (Refer to ELECTRICAL/BATTERY SYSTEM - STANDARD PROCEDURE)
Perform Diagnostic Verification Test and clear any faults. (Refer to BRAKES - DIAGNOSIS AND TESTING)