LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2004 >> Sebring GTC, Standard >> Repair and Diagnosis (Single Page) >> Engine Performance >> Remove, Overhaul & Install >> Fuel Delivery System - Except Coupe >> Fuel Pump Module >> Installation

Fuel Pump Module: Installation

  1. Wipe seal area of tank clean and place a new seal in position in the tank opening.
  2. Position fuel pump in the tank.
  3. Position the lockring over the fuel pump module.
  4. Tighten the lockring using a brass punch and hammer.
  5. Connect the electrical connector.
  6. Connect the fuel line to the fuel pump.
  7. Install the fuel tank, refer to FUEL TANK .
  8. Lower vehicle.
  9. Connect the battery cable.
  10. Fill fuel tank. Use the DRB III® scan tool to pressurize the fuel system. Check for leaks.
scientia non olet · About LEMON Manuals