Door System - Front: Door: Installation
- Steady door on lifting device and place door into position.
- Loosely install bolts attaching upper hinge to door end frame (Fig 2
).
- Loosely install bolts attaching lower hinge to door end frame.
- Connect door harness to body wiring harness.
Courtesy of DAIMLERCHRYSLER CORP.
Courtesy of DAIMLERCHRYSLER CORP.
- Ensure lock tab attaching wire connector halves together is connected.
- Connect positive lock slide on the side of the wire connectors.
- Engage clips attaching door harness wire connector to inner fender brace (Fig 1
).
- Remove front wheelhouse splash shield. (Refer to FRONT WHEELHOUSE SPLASH SHIELD
).
- Install screws attaching door check strap to A-pillar (Figure
). (Refer to INSTALLATION
).
- Check door for alignment. (Refer to GAP AND FLUSH
).
- Tighten hinge bolts. (Refer to INSTALLATION
).