LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2004 >> Pacifica AWD >> Repair and Diagnosis >> Body & Frame >> Exterior/Interior Trim >> Power Liftgate System >> Liftgate Light Bar >> Installation

Liftgate Light Bar: Installation

  1. Place the liftgate light bar wiring harness through liftgate.
  2. Line up the four liftgate light bar retaining screws and install (Figure ) and (Figure ).
  3. Connect the liftgate light bar electrical connector inside the liftgate.
  4. Install the liftgate inner trim panel (Refer to TRIM PANEL  ).
  5. Connect the battery negative cable.
  6. Verify vehicle and system operation.
  7. Close hood.
scientia non olet · About LEMON Manuals