LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2004 >> Pacifica AWD >> Repair and Diagnosis >> Body & Frame >> Door Locks >> Power Door Locks >> Driver Cylinder Lock Switch >> Installation

Driver Cylinder Lock Switch: Installation

  1. Install the switch on the key cylinder in the door handle. Ensure that switch is in 12 O'clock position.
  2. Route wire down through link rods.
  3. Install three clips to security shield.
  4. Connect wire harness connector.
  5. Install the door trim panel (Refer to TRIM PANEL ).
  6. Connect the battery negative cable.
  7. Verify system operation.
scientia non olet · About LEMON Manuals