Monitored & Set Conditions

Circuit is monitored in 2 tests. Test No. 1: Vehicle speed must be greater than 20 MPH to enable. TEST No. 2: Speed must be zero MPH and brake switch indicate on. DTC will set in Test No. 1 if vehicle speed goes to zero MPH without brake input. Condition must be repeated 15 times to set fault. DTC will set in Test No. 2 if vehicle speed goes above 20 MPH for more than 6.0 seconds without a change in brake state. Condition must be repeated 15 times to set fault. This is a two trip fault.