LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2004 >> Intrepid SE >> Repair and Diagnosis (Single Page) >> Body & Frame >> Body, Cab Control Systems >> Body Diagnostic Procedures >> Diagnostic Information And Procedures >> Verification Tests >> Memory Heated System Verification Test - Ver 1

Memory Heated System Verification Test - Ver 1

  1. Reconnect all previously disconnected components and connectors.
  2. If any Memory Heated Seat Memory Module Trouble Codes are present, erase at this time.
  3. If the Memory Seat Module was replaced, use the DRBIII and Reset Guard Bands.
  4. With the Memory Switch on the Driver's Door, program the Driver's Seat #1 Button to a desired position and Driver #2 Button to a different position.
  5. Remove the Ignition Key and close all Doors to allow the Body Control Module to time out, about 30 seconds.
  6. Verify that both Memory positions can be recalled from the RKE transmitter and the Memory Switch on the Driver's Door.
  7. Turn the ignition on, and with the DRBIII, erase all Diagnostic Trouble Codes from ALL modules. Start the engine and allow it to run for 2 minutes and fully operate the system that was malfunctioning.
  8. Turn the ignition off and wait 5 seconds. Turn the ignition on and using the DRBIII, read DTC's from ALL modules.

Are any DTC's present or is the original complaint still present?

scientia non olet · About LEMON Manuals