LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2004 >> Crossfire Automatic >> Repair and Diagnosis (Single Page) >> Engine Performance >> System >> Engine Controls - Electrical Diagnostics >> Diagnosis And Testing >> DTC P0335: Crankshaft Position Sensor Circuit >> Diagnostic Test >> 1. Check For Current DTC

1. Check For Current DTC

WARNING: WHEN THE ENGINE IS OPERATING, DO NOT STAND IN A DIRECT LINE WITH THE FAN. DO NOT PUT YOUR HANDS NEAR THE PULLEYS, BELTS OR FAN. DO NOT WEAR LOOSE CLOTHING.
NOTE: If the PCM detects and stores a DTC, the PCM also stores the engine/vehicle operating conditions under which the DTC was set. Some of these conditions are displayed on the DRB III(R) at the same time the DTC is displayed.
NOTE: Before erasing stored DTCs, record these conditions. Attempting to duplicate these conditions may assist when checking for a DTC.

Turn the ignition on.

With the DRB III(R), erase PCM DTCs.

NOTE: It maybe necessary to road test the vehicle for this DTC to set.

With the DRB III(R), read the PCM DTCs.

Did this DTC set again? 

  1. Yes  >> Go To 2
  2. No  >> Go To 12 
scientia non olet · About LEMON Manuals