LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2003 >> Voyager LX, 3.3 R >> Repair and Diagnosis >> Electrical >> Charging Systems >> Charging System - Generators & Regulators >> Verification Tests >> Transmission Verification Test VER-1

Transmission Verification Test VER-1

  1. Connect the DRBIII(R) to the Data Link Connector (DLC).
  2. Reconnect any disconnected components.
  3. With the DRBIII(R), erase all Transmission DTC's, also erase the PCM DTC's.
  4. With the DRBIII(R), display transmission temperature.
  5. If the Transmission Control Module (TCM) or torque converter has been replaced or if the transmission has been repaired or replaced it is necessary to perform the DRBIII(R) Quick Learn Procedure and reset the "Pinion Factor".
  6. Road test the vehicle. With the DRBIII(R), monitor the engine RPM. Make 15-20; 1-2, 2-3, 3-4 upshifts. Perform these shifts from a standing start to 45 MPH with a constant throttle opening of 20-25 degrees.
  7. Below 25 MPH, make 5-8 wide open throttle kickdowns to 1st gear. Allow at least 5 seconds each in 2nd and 3rd gear between each kickdown.
  8. For specific DTC, drive the vehicle to the Symptom's When Monitored/When Set Conditions to verify the DTC repair.
  9. Check for Diagnostic Trouble Codes (DTC's) during the road test. If a DTC sets during the road test, return to the symptom list and follow the path.
  10. Erase P0700 DTC in the PCM to turn the MIL light off after making transmission repairs. This will turn the MIL off.
  11. If any DTC's were set during the road test, refer to symptom list for appropriate diagnostic tests. If no DTC's were set, repair is complete.
scientia non olet · About LEMON Manuals