LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2003 >> Voyager LX, 3.3 R >> Repair and Diagnosis >> Body & Frame >> Door Locks >> Power Liftgate System >> Exterior Handle Switch >> Installation

Exterior Handle Switch: Installation

  1. Install the handle switch in the light bar assembly.
    2. NOTE: Be certain wires are reinstalled in the correct wire cavities. Failure to do so could result in damage to the handle switch. Refer to Wiring Diagrams if previous notes were not made.
  2. Locate the two wires going to the exterior handle switch. Install the wires through the grommet and in the large connector. Secure with a tie strap. Refer to the WIRING for detailed instructions.
  3. Install the rear light bar. Refer to BODY for the procedure.
  4. Install the liftgate trim panel. Refer to BODY for the procedure.
  5. Connect the negative battery cable.
  6. Using an appropriate scan tool, check any erase any power liftgate control module diagnostic trouble codes.
  7. Verify power liftgate system and handle switch operation. Cycle the power liftgate through one complete open and close cycle, this will allow the power liftgate control module to relearn its cycle with the new components.
scientia non olet · About LEMON Manuals