LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2003 >> Town & Country Base >> Repair and Diagnosis >> Accessories & Equipment >> Memory Modules >> Adjustable Pedals System >> Removal & Installation >> Adjustable Pedal Switch >> Installation

Adjustable Pedal Switch: Installation

  1. Guide adjustable pedal switch wiring through mounting hole in lower shroud.
  2. Align switch retainers with notches in mounting hole and snap the switch into place.
  3. Connect adjustable pedal switch wiring connector along left side of column.
  4. Install the lower shroud with adjustable pedal switch. Install screws fastening steering column shrouds to steering column.
  5. Install knee blocker reinforcement plate.
  6. Connect parking brake release link to release handle.
  7. Install data link diagnostic connector to mounting hole in reinforcement plate.
  8. Install lower steering column cover/knee blocker.
  9. Install silencer panel below lower steering column cover/knee blocker.
  10. Connect ground cable to negative post of battery.
  11. Connect scan tool (DRB-III(R)) to data link diagnostic connector located below steering column.
  12. Turn ignition key to ON position.
  13. Using scan tool, check for and clear any existing adjustable pedal fault codes.
  14. Test operation of adjustable pedals, memory sets and RKE (if equipped). If applicable, reset radio and clock.
  15. Recheck for any fault codes.
  16. Turn key to OFF and remove scan tool from vehicle.
scientia non olet · About LEMON Manuals