LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2003 >> Sebring LXi, 2D Coupe, Standard >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - System & Component Testing - Coupe - 3.0L >> Miscellaneous Controls >> Condenser & Radiator Fan Controls >> Fan Controller

Fan Controller

  1. Disconnect condenser fan motor connector from fan controller. See Figure . Start engine and allow to idle. Maintain coolant temperature at 176°F (80°C) or less. Turn A/C switch on.
  2. Using DVOM, measure voltage across fan controller condenser fan output terminals. Voltage should vary between zero volts, 5.6-10.8 volts and 10.6-15.8 volts. If voltage is not as specified, replace radiator fan motor and fan controller.
scientia non olet · About LEMON Manuals