LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2003 >> Sebring GTC, 2.7 T, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 31 (Body Control Modules - Except Coupe) >> Removal & Installation >> Body Control Module >> Removal & Installation

Removal & Installation

WARNING: This page is about a different car, the 2002 Dodge Stratus and 2002 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect negative battery cable. Body Control Module (BCM) and junction block are attached to each other. Open driver's door and remove end cap from instrument panel. Remove instrument panel center bezel and instrument cluster hood.
  2. Disconnect electrical connectors from rear of junction block. Remove junction block from left side of instrument panel by pulling junction block/BCM straight down and out of mount.
  3. Remove 2 screws attaching BCM to junction block and disconnect internal connector to remove. To install, reverse removal procedure. Program BCM after installation. See BODY CONTROL MODULE  under PROGRAMMING.
scientia non olet · About LEMON Manuals