LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2003 >> Sebring GTC, 2.7 R, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 11 (Engine Controls - System & Component Testing - Coupe - 2.4L) >> Miscellaneous Controls >> Ignition Switch/Starting System >> Starter Relay

Starter Relay

WARNING: This page is about a different car, the 2002 Dodge Stratus and 2002 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.

Remove starter relay, located in underhood fuse/relay box. See Figure . Using jumper wires, connect battery voltage to terminal No. 3 and battery ground to terminal No. 1. With battery connected, 2 ohms or less should exist between starter relay terminals No. 2 and 5. If resistance is greater than 2 ohms, replace starter relay. Remove jumper wires. With battery disconnected, continuity should not exist between starter relay terminals No. 2 and 5. If continuity exists, replace starter relay.

scientia non olet · About LEMON Manuals