LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2002 >> Voyager EC >> Repair and Diagnosis >> Brakes >> Traction Control >> Anti-Lock Brake System >> Rear Wheel Speed Sensor - AWD >> Removal

Rear Wheel Speed Sensor - AWD: Removal

  1. Raise vehicle.
    2. CAUTION: When disconnecting speed sensor cable from vehicle wiring harness be careful not to damage pins on the electrical connectors. Also, inspect connectors for any signs of previous damage.
  2. Remove grommet from floor pan of vehicle and disconnect speed sensor cable connector from vehicle wiring harness.
    3. CAUTION: When removing rear wheel speed sensor cable from routing clips, be sure not to damage the routing clips. Routing clips that are molded onto the brake hose will require replacement of the brake hose if damaged during removal or installation of the speed sensor cable.
  3. Carefully remove speed sensor cable from press-in routing clips along brake hose and tubing.
  4. Remove bolt securing wheel speed sensor cable metal clip to rear of axle. Remove metal clip from cable if necessary.
    5. CAUTION: If speed sensor head has seized due to corrosion, do not use pliers on speed sensor head in an attempt to remove it. Use a hammer and a punch and tap mounting flange edge side-to-side, rocking the sensor until free.
  5. Remove wheel speed sensor head attaching bolt.
  6. Remove wheel speed sensor head from the axle, and remove sensor from vehicle.
scientia non olet · About LEMON Manuals