Power Seat Switch
Remove power seat switch from mounting position. See POWER SEAT SWITCH under REMOVAL & INSTALLATION. Using ohmmeter, check continuity between specified terminals at power seat switch, as switch is operated. See POWER SEAT SWITCH CONTINUITY TEST table. See Fig 1 . If continuity does not exist between specified terminals, replace power seat switch.
POWER SEAT SWITCH CONTINUITY TEST
| Switch Position | Left Seat Switch Terminal No. | Right Seat Switch Terminal No. |
|---|---|---|
| Off | 1 & 2 | 1 & 2 |
| ..... | 1 & 3 | 1 & 3 |
| ..... | 1 & 4 | 1 & 4 |
| ..... | 1 & 6 | 1 & 6 |
| ..... | 1 & 7 | 1 & 7 |
| ..... | 1 & 8 | 1 & 8 |
| ..... | 1 & 9 | 1 & 9 |
| ..... | 1 & 10 | 1 & 10 |
| Front Riser Up | 1 & 10 | 1 & 7 |
| ..... | 5 & 7 | 5 & 10 |
| Front Riser Down | 1 & 7 | 1 & 10 |
| ..... | 5 & 10 | 5 & 7 |
| Center Switch Forward | 1 & 3 | 1 & 3 |
| ..... | 5 & 6 | 5 & 6 |
| Center Switch Rearward | 1 & 6 | 1 & 6 |
| ..... | 3 & 5 | 3 & 5 |
| Rear Riser Up | 1 & 9 | 1 & 8 |
| ..... | 5 & 8 | 5 & 9 |
| Rear Riser Down | 1 & 8 | 1 & 9 |
| ..... | 5 & 9 | 5 & 8 |
| Recliner Up | 1 & 4 | 1 & 4 |
| ..... | 2 & 5 | 2 & 5 |
| Recliner Down | 1 & 2 | 1 & 2 |
| ..... | 4 & 5 | 4 & 5 |