LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2002 >> Prowler >> Repair and Diagnosis >> Body & Frame >> Seats >> Seat System >> Seat Assembly >> Installation

Seat Assembly: Installation

NOTE: Ensure that the rearmost edge of the upper and lower tracks are aligned and flush prior to installation.
NOTE: Do not cycle seat track until front seat track bolts are installed as tracks can become misaligned.
  1. Carefully position seat assembly over the rear studs.
  2. Connect seat belt wire connector (driver's side only).
  3. Install front bolts attaching seat to floor. Tighten bolts to 54 N.m (40 ft. lbs.) torque.
  4. Install rear nuts attaching seat to floor. Tighten nuts to 54 N.m (40 ft. lbs.) torque.
  5. Install seat belt strap through seat belt guide on seat back. Install seat belt anchor bolt
  6. Verify proper operation.
scientia non olet · About LEMON Manuals