LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2002 >> PT Cruiser Limited, Standard >> Repair and Diagnosis >> Body & Frame >> Body, Cab Control Systems >> Body Control Modules >> System Tests >> Instrument Cluster >> Rear Fog Lamp Indicator Inoperative (BUX Only)

Rear Fog Lamp Indicator Inoperative (BUX Only)

NOTE: After making any repairs, perform BODY VERIFICATION TEST  under VERIFICATION TESTS.
  1. Ensure that the rear fog lamps operate correctly before proceeding with this test. Turn the ignition off. Disconnect the instrument cluster C2 harness connector. See Figure. Turn the rear fog lamp switch on. Using a 12-volt test light connected to ground, check the rear fog lamp indicator circuit. If the test light illuminated brightly go to the next step. If the test light did not illuminate brightly repair the rear fog lamp indicator circuit for an open.
  2. Turn the ignition off. Remove the instrument cluster. See INSTRUMENT CLUSTER under REMOVAL & INSTALLATION in appropriate ANALOG INSTRUMENT PANELS article. Remove the inoperative LED. See INSTRUMENT CLUSTER BULBS & LED under REMOVAL & INSTALLATION in appropriate ANALOG INSTRUMENT PANELS article. Using a DVOM, select DIODE MODE, and attach the leads across the LED. Ensure that the Red lead is on the positive of the LED. If the LED illuminated, the test is complete. If the LED did not illuminate, replace the rear fog lamp indicator LED.
scientia non olet · About LEMON Manuals