LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2002 >> Neon LE, Standard >> Repair and Diagnosis >> Steering >> Power Steering >> Steering System >> Power Steering Pressure Switch >> Removal

Power Steering Pressure Switch: Removal

NOTE: Before proceeding, refer to WARNINGS AND CAUTIONS ).
  1. Disconnect negative battery cable from the negative post of the battery. Be sure cable is isolated from negative post on battery.
  2. Raise the vehicle.
  3. Locate the power steering fluid pressure switch on the back side of the power steering gear. (Figure).
  4. Remove the vehicle wiring harness connector from the power steering fluid pressure switch.
    NOTE: When removing and installing the power steering pressure switch, use a 7/8 inch deep well socket. The deep well socket will prevent damage to the plastic electrical connector area of the power steering fluid pressure switch.
  5. Unscrew and remove the power steering fluid pressure switch from the power steering gear.
scientia non olet · About LEMON Manuals