LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2002 >> Intrepid Base >> Repair and Diagnosis >> Steering >> Steering Wheel & Steering Column >> Steering Wheel >> Installation

Steering Wheel: Installation

  1. Confirm that:
    • The steering wheel position is a half turn (180 degrees) to the right (clockwise).
    • The column is locked with the ignition cylinder lock.
    • Check that the turn signal stalk is in the neutral position.
    CAUTION: When installing the steering wheel, use care not to damage the steering wheel finish. The wood grain on some steering wheels can be easily marred.
  2. Pull all wires through the larger opening of the hub area on the wheel. Install steering wheel ensuring the flats on hub align with the clockspring. Ensure leads do not get pinched under the steering wheel.
  3. Install retaining nut, and torque it to 61 N.m (45 ft.lbs.).
  4. Route speed control wires through the slots in the steering wheel back cover.
  5. Connect the horn lead wire and the airbag lead wire to the airbag module.
  6. If optional audio control switches are present on the rear of the steering wheel, connect the 4-way connector lead from the clockspring to the steering wheel wiring harness lead. Once connected, place the connector in back cover formation located at the 12 O'clock position.
  7. Install the drivers airbag and torque bolts to 8 N.m (75 in. lbs.).
  8. Connect the speed control wires to the switches and install switches. Torque screws to 1.5 N.m (13 in. lbs.).
WARNING: Do not connect the battery negative cable remote terminal at this time. Refer to AIR BAG SAFETY PRECAUTIONS and DISABLING & ACTIVATING AIR BAG SYSTEM .
scientia non olet · About LEMON Manuals