Rear Shelf Trim Panel: Installation
WARNING: This page is about a different car, the 2004 Dodge Intrepid, 2004 Chrysler Intrepid, 2004 Chrysler Concorde, and 2004 Chrysler 300M. However, it is still accessible from the selected car via links, so may be relevant.
- Place rear shelf trim panel in position in vehicle.
- Feed center seat belt and bezel through rear trim panel.
- Connect CHMSL wire connector.
- Push parcel shelf trim rearward toward rear glass and engage clips.
- Insert push pin fasteners into position.
- Install quarter trim lower and upper panels.
- Install center seat belt anchor bolt. Tighten to 40 N.m (29 ft. lbs.) torque.
- Install seat back and cushion.