Cable - Remote Lock Actuator: Installation
WARNING: This page is about a different car, the 2004 Dodge Intrepid, 2004 Chrysler Intrepid, 2004 Chrysler Concorde, and 2004 Chrysler 300M. However, it is still accessible from the selected car via links, so may be relevant.
- Install the cable into the door and through the hole in the door shut face.
- Install and tighten the cable nut.
- Install the knob lock nut and the actuator knob.
- Tighten the lock nut.
- Attach the cable to the latch and engage the clip.
- Install the support bracket screws and verify correct actuator operation.
- Loosen the support bracket screws and adjust the cable if necessary.
- Replace any support tie straps, if equipped.
- Install the watershield and the trim panel. (Refer to TRIM PANEL )