Headlamp Leveling Motor - Export: Removal
WARNING: This page is about a different car, the 2004 Dodge Intrepid, 2004 Chrysler Intrepid, 2004 Chrysler Concorde, and 2004 Chrysler 300M. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the headlamp assembly from the vehicle (Refer to HEADLAMP UNIT ).
- Disconnect the headlamp leveling motor wire connector.
- Place the headlamp assembly on a bench with a protective surface under the lens to prevent damage.
- Grasp the leveling motor and rotate approximately 45 degrees to unlatch it from the lamp housing.
- Using an appropriate prying tool, place the edge of tool between leveling motor gasket and headlamp assembly. Pry the leveling motor up and out.
NOTE:
Significant force will be required to unsnap the leveling motor pushrod from the headlamp reflector mechanism.
CAUTION:
Be certain not to damage the lamp housing sealing surface.