LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2002 >> Intrepid Base >> Repair and Diagnosis >> Engine Performance >> Remove, Overhaul & Install >> Engine Controls - Removal, Overhaul & Installation >> Fuel Systems >> Fuel Tank >> Installation

Fuel Tank: Installation

  1. Raise the fuel tank on the transmission stand. Install fuel pump electrical connector into hole in the body. Connect wiring harness to fuel tank pin, if removed. Connect wiring harness to heat shield, if removed.
  2. Connect the purge and vent lines. Raise tank into position and install tank straps. Install the fuel filler tube and tighten the clamp. Reposition the stabilizer bar and install bolts. Tighten bolts to specification. See TORQUE SPECIFICATIONS .
  3. Lower vehicle. Connect the fuel pump electrical connector that is under the rear seat. Install the rear seat. Connect the negative battery cable. Fill fuel tank. Use the DRBIII® scan tool to pressurize the fuel system. Check for leaks.
scientia non olet · About LEMON Manuals