Ignition Switch

Remove ignition switch. See IGNITION SWITCH under REMOVAL & INSTALLATION. Check continuity between appropriate switch terminals with switch in specified position. See IGNITION SWITCH CONTINUITY table. See Fig 1 . If continuity is not as specified, replace ignition switch.

IGNITION SWITCH CONTINUITY

Switch Position

⁽¹⁾ Continuity Between Terminals No.

ACC

5 & 6

LOCK

⁽²⁾

OFF

1 & 5

RUN

1, 4, 5 & 6; 7 & 10

START

1, 4, 5 & 9

⁽¹⁾	With key in ignition, continuity exists between terminals No. 2 and 3 for key-in switch.

⁽²⁾	Continuity should not exist between any terminals.

Fig 1: Identifying Ignition Switch Connector Terminals

Courtesy of CHRYSLER CORP.