LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Voyager Base, 2.4 B >> Repair and Diagnosis >> External Pages >> Different car >> Section 8 (Automatic HVAC Systems) >> Removal & Installation >> Receiver-Drier >> Installation

Removal & Installation: Receiver-Drier: Installation

WARNING: This page is about a different car, the 2002 Dodge Grand Caravan and 2002 Chrysler Town & Country. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the filter-drier and mounting bracket unit onto the weld studs on the side of the right front strut tower. Install and tighten the 2 nuts that secure the filter-drier mounting bracket to the studs.
  2. Remove the tape or plugs from the liquid line rear section fitting for the filter-drier and the filter-drier outlet port. Lubricate a NEW rubber O-ring seal with clean refrigerant oil and install it on the liquid line fitting.
  3. Reconnect the liquid line fitting to the filter-drier outlet port on the top of the filter-drier. Install and tighten the screw that secures the liquid line fitting to the filter-drier.
  4. Remove the tape or plugs from the liquid line front section fitting for the filter-drier and the filter-drier inlet port. Lubricate a NEW rubber O-ring seal with clean refrigerant oil and install it on the liquid line fitting.
  5. Reconnect the liquid line fitting to the filter-drier inlet port on the top of the filter-drier. Install and tighten the screw that secures the liquid line fitting to the filter-drier. Reinstall the air cleaner housing into the right side of the engine compartment.
  6. Evacuate and charge the refrigerant system. See RECOVERY, EVACUATION & RECHARGING in GENERAL SERVICING PROCEDURES article in GENERAL SERVICING.
scientia non olet · About LEMON Manuals