Brake Switch
NOTE:
If brake switch is removed, it must be replaced. See BRAKE SWITCH under REMOVAL & INSTALLATION.
Disconnect brake switch 6-pin connector. See Fig 1. Using DVOM, measure for continuity at brake switch. See Figure. See BRAKE SWITCH CONTINUITY table. If continuity is not as specified, replace brake switch.
BRAKE SWITCH CONTINUITY
| Switch Plunger Position (1) | Check Between Terminals No. | Continuity | ||
|---|---|---|---|---|
| Released | 1 & 2 | Yes | ||
| 3 & 4 | No | |||
| 5 & 6 | No | |||
| Depressed | 1 & 2 | No | ||
| 3 & 4 | Yes | |||
| 5 & 6 | Yes | |||
|
||||