LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LXi, 2D Convertible >> Repair and Diagnosis >> Body & Frame >> Body, Cab Control Systems >> Body Control Modules - Except Coupe >> System Tests >> Instrument Cluster Systems >> No PCM Bus Messages Received

No PCM Bus Messages Received

NOTE: After making any repairs, perform BODY VERIFICATION TEST  under VERIFICATION TESTS.
  1. Connect scan tool to Data Link Connector (DLC) located under left side of instrument panel. See Figure . Turn ignition on. Using scan tool, attempt to communicate with Powertrain Control Module (PCM). If scan tool does not communicate with PCM, diagnose communication problem. See NO RESPONSE FROM PCM (PCI BUS)  under COMMUNICATIONS. If scan tool communicated with PCM, go to next step.
  2. Using scan tool, erase DTCs Cycle ignition off and on and wait about one minute. Using scan tool, check for DTCs. If DTC resets, replace instrument cluster. If DTC does not reset, no problem is indicated at this time. Test is complete.
scientia non olet · About LEMON Manuals