Removal (Neon)
- Fuel level sensor is mounted on fuel pump module. See Fig 1. Remove fuel pump module. See FUEL PUMP MODULE . Depress retaining tab and disconnect fuel pump and fuel level sensor harness connector from bottom side of fuel pump module harness connector. See Figure.
- Remove Blue locking wedge from inside of harness connector for fuel pump and fuel level sensor. See Fig 2.CAUTION: Note location of wires for fuel level sensor in harness connector for fuel pump and fuel level sensor for installation reference. Wires must be installed in correct location.
- Mark wire location in harness connector for fuel pump and fuel level sensor for installation reference. Wires for fuel level sensor must be removed from fuel pump and fuel level sensor harness connector.
- Using small screwdriver, lift locking finger away from terminal on wire. Push wire and terminal out of harness connector.
- Slide wires for fuel level sensor through opening on inside of fuel pump module. Slide fuel level sensor out of installation channel in fuel pump module.