LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2000 >> Voyager Base, 3.3 G >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - System & Component Testing - Fwd Vans >> Engine Sensors & Switches >> Brake Switch

Brake Switch

  1. Brake switch is located near top of brake pedal. Disconnect electrical connector from brake switch. It may be necessary to remove brake switch for access to electrical connector. If necessary to remove brake switch, see BRAKE SWITCH under ENGINE SENSORS & SWITCHES in REMOVAL, OVERHAUL & INSTALLATION - FWD VANS article.
  2. Pull plunger on brake switch fully outward. See Fig 1 . Check for continuity between terminals No. 5 and 6 on brake switch. Continuity should exist. If continuity is not as specified, replace brake switch.
  3. Push plunger on brake switch fully inward. Check for continuity between terminals No. 1 and 2, and 3 and 4 on brake switch. Continuity should exist. If continuity is not as specified, replace brake switch.
Fig 1: Positioning Plunger & Identifying Typical Brake Switch Terminals
G96B01689Courtesy of CHRYSLER CORP.
scientia non olet · About LEMON Manuals