Power Mirror Motor
Remove power mirror switch and disconnect wiring connector. See POWER MIRROR SWITCH
under REMOVAL & INSTALLATION. Using 2 jumper wires, connect one jumper to a 12-volt source and the other jumper wire to a good ground. Connect other end of jumper wires to specified power mirror switch harness connector terminals. See LEFT POWER MIRROR MOTOR TEST
and RIGHT POWER MIRROR MOTOR TEST
tables. If mirror operation is not as specified, check for open or short circuit between switch and power mirror. Repair as necessary. If wiring harness is okay, replace mirror assembly as necessary. See Fig 1
.
LEFT POWER MIRROR MOTOR TEST
| Apply 12 Volts To Switch Connector Terminal No. |
Ground Terminal No. |
Mirror Operation |
| 12 |
6 |
Up |
| 7 |
6 |
Left |
| 6 |
12 |
Down |
| 6 |
7 |
Right |
| 5 |
11 |
|
RIGHT POWER MIRROR MOTOR TEST
| Apply 12 Volts To Switch Connector Terminal No. |
Ground Terminal No. |
Mirror Operation |
| 13 |
1 |
Up |
| 8 |
1 |
Left |
| 1 |
13 |
Down |
| 1 |
8 |
Right |
| 5 |
11 |
|
Courtesy of CHRYSLER CORP.