LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2000 >> Sebring JXi >> Repair and Diagnosis (Single Page) >> Body & Frame >> Body, Cab Control Systems >> Body Control Modules - Except Coupe >> System Tests >> Exterior Lighting Systems >> Headlight Time Delay Feature Inoperative

Headlight Time Delay Feature Inoperative

  1. Connect scan tool to DLC. DLC is located above hood release handle on driver's kick panel. Select BODY CONTROL MODULE on scan tool. If scan tool displays NO RESPONSE, go to BATTERY POWER TO MODULE DISCONNECT; IGNITION VOLTAGE TOO LOW; NO RESPONSE FROM BCM (BAT PWR DISCON'D); BATTERY POWER TO MODULE  under COMMUNICATIONS. If scan tool displays CCD BUS FAILURE, go to appropriate bus failure procedure under COMMUNICATIONS . If neither message is displayed, go to next step.
  2. Select INPUT/OUTPUT on scan tool. Display IGN RUN/START state. If scan tool does not indicate OPEN, go to next step. If scan tool indicates OPEN, go to BATTERY POWER TO MODULE DISCONNECT; IGNITION VOLTAGE TOO LOW; NO RESPONSE FROM BCM (BAT PWR DISCON'D); BATTERY POWER TO MODULE  under COMMUNICATIONS.
  3. Turn ignition on. Using scan tool, actuate headlight relay. If headlights toggle on and off, stop actuation of headlight relay and go to next step. If headlights do not toggle on and off, stop actuation of headlight relay and go to step  6.
  4. Turn headlight switch to ON position. Using scan tool, read low beam sense status. Turn headlight switch OFF, and then to ON position. If scan tool displays LOW BEAM SENSE: OFF and then LOW BEAM SENSE: ON, go to next step. If scan tool display does not match headlight switch positions, replace junction block.
  5. Replace BCM. See BODY CONTROL MODULE (BCM)  under REMOVAL & INSTALLATION.
  6. Turn ignition on. Replace headlight delay relay with known good relay. See Figure. Using scan tool, actuate headlight relay. If headlights toggle on and off, stop actuation of headlight relay and replace relay. If headlights do not toggle on and off, stop actuation of headlight relay and go to next step.
  7. Using DVOM, measure voltage between ground and terminal No. 1 on headlight delay relay socket. If voltage is greater than 10 volts, go to next step. If voltage is 10 volts or less, replace junction block.
  8. Using DVOM, measure voltage between ground and terminal No. 3 on headlight delay relay socket. See Figure. If voltage is greater than 10 volts, go to next step. If voltage is 10 volts or less, replace junction block.
  9. Connect a jumper wire between terminals No. 1 and 5 on headlight delay relay socket. See Figure. If headlights illuminate, go to next step. If headlights do not illuminate, replace junction block.
  10. Replace BCM. See BODY CONTROL MODULE (BCM)  under REMOVAL & INSTALLATION.
scientia non olet · About LEMON Manuals