Washer Reservoir: Installation
WARNING: This page is about a different car, the 2004 Dodge Intrepid, 2004 Chrysler Intrepid, 2004 Chrysler Concorde, and 2004 Chrysler 300M. However, it is still accessible from the selected car via links, so may be relevant.
- Transfer fluid level sensor, pump, and washer fluid to new reservoir (Figure ).
- Place washer reservoir into vehicle into the mounting position.
- Install the four mounting bolts to the washer reservoir (Figure ).
- Reach up behind the washer reservoir and place the filler tube onto the rear of the reservoir.
- Connect the washer hose to the washer pump outlet.
- Connect the wire connectors to the reservoir pump and float sensor.
- Install the front fascia as necessary (left side only and use a 2x4 to prop left edge of fascia away from body). Refer to FRONT FASCIA for installation. .
- Lower vehicle from hoist.
- Connect the negative battery cable remote terminal to the remote battery post.