Side Repeater Lamp Test

WARNING: This page is about a different car, the 2004 Dodge Intrepid, 2004 Chrysler Intrepid, 2004 Chrysler Concorde, and 2004 Chrysler 300M. However, it is still accessible from the selected car via links, so may be relevant.

Some vehicles are equipped with side repeater lamps integral to the sideview mirror. If the LED's within the mirror do not operate and the other within the system do, proceed with the side repeater lamp test. Refer to the appropriate POWER MIRRORS . The wiring information includes wiring diagrams, proper wire and connector repair procedures, details of wire harness routing and retention, connector pin-out information and location views for the various wire harness connectors, splices and grounds.

Remove the door trim panel (Refer to TRIM PANEL ).
Disconnect wire harness connector from mirror.
Turn the ignition to the ON position and actuate the turn signal on the appropriate side.
Using a 12-volt test light, check for voltage at pin 12 (left side) or pin 8 (right side) while turn signals are functioning.
Check for ground at pin 1.

If the test light does not illuminate, check for a broken or shorted wire.

If the test light illuminates, the wiring circuit between the turn signal switch and the mirror wire harness connector is OK. Replace the mirror assembly.