LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2000 >> Intrepid Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 57 (Disc Brakes) >> Bleeding Brake System >> Bleeding Procedure >> Pressure Bleeding

Pressure Bleeding

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2004 Dodge Intrepid, 2004 Chrysler Intrepid, 2004 Chrysler Concorde, 2004 Chrysler 300M, and 2003 Dodge Intrepid. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Follow pressure bleeder manufacturer's instructions for use of pressure bleeding equipment.
  1. Remove filler cap from the top of fluid reservoir on master cylinder.
  2. Install Adapter, Special Tool (8224), in the caps place on the reservoir.
  3. Attach Bleeder Tank, Special Tool (C-3496-B), or equivalent, to Special Tool (8224). Pressurize the system following the pressure bleeder manufacturer's instructions.
  4. Remove rubber dust caps from all 4 bleeder screws.
  5. Starting at the first wheel circuit as listed earlier, attach a clear hose to the bleeder screw at that wheels brake caliper or wheel cylinder and feed the other end of hose into a clear jar containing enough fresh brake fluid to submerge the end of the hose.
    6. CAUTION: Open the bleeder screw at least one full turn when instructed. Some air may be trapped in the brake lines or valves far upstream, as far as ten feet or more from the bleeder screw. If the bleeder screw is not opened sufficiently, fluid is restricted causing a slow, weak fluid discharge. This WILL NOT get all the air out. Therefore, it is essential to open the bleeder screw at least one full turn to allow a fast, large volume discharge of brake fluid.
  6. Open bleeder screw at least one full turn or more to obtain an adequate flow of brake fluid.
  7. After 4-8 ounces of brake fluid has been bled through the brake hydraulic circuit. and an air-free flow (no bubbles) is maintained in the clear plastic hose and jar, close the bleeder screw.
  8. Bleed the remaining wheel circuits in the same manner until all air is removed from the brake hydraulic system.
  9. Check brake pedal travel. If pedal travel is excessive or has not improved, some air may still be trapped in the hydraulic system. Re-bleed the brake system as necessary.
  10. Reinstall all 4 bleeder screw dust caps.
  11. Test drive vehicle to ensure brakes are operating properly and pedal feel is correct.
scientia non olet · About LEMON Manuals