A/C Discharge Line: Removal
WARNING: This page is about a different car, the 2004 Dodge Intrepid, 2004 Chrysler Intrepid, 2004 Chrysler Concorde, and 2004 Chrysler 300M. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
REVIEW THE WARNINGS BEFORE PERFORMING THE FOLLOWING OPERATION. (Refer to
- WARNING )
- Open the hood and disconnect the negative battery cable remote terminal from the remote battery post.
- Recover the refrigerant from the system. (Refer to - STANDARD PROCEDURE - REFRIGERANT RECOVERY )
- Disconnect the a/c pressure transducer wire harness (Figure) and (Figure).
- Remove the a/c pressure transducer. (Refer to REMOVAL )
- Disconnect the discharge line at the compressor using an M10 Hex wrench for 2.7L, and a 6 mm alien wrench for 3.2/3.5L.CAUTION: Cap all lines that are not being replaced and cap the expansion valve tubes.
- Disconnect the discharge line at the A/C condenser using an M10 Hex wrench.