LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2000 >> Intrepid Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 103 (Frame System & Bumper System) >> Front Fascia >> Installation >> Installation

Front Fascia: Installation: Installation

WARNING: This page is about a different car, the 2004 Dodge Intrepid, 2004 Chrysler Intrepid, 2004 Chrysler Concorde, and 2004 Chrysler 300M. However, it is still accessible from the selected car via links, so may be relevant.
  1. Connect wire connectors.
  2. Place fascia in position on vehicle, by fitting foam to bumper reinforcement. Use care not to scratch fender. Tape may be put on fender for protection.
  3. Install the top center fasteners, to upper radiator closure panel.
  4. Align fascia to bumper reinforcement.
  5. Align the two fascia studs to the fender vertical attachments, at the same time align the fascia groove on the horizontal flange with the fender fasteners. Push fascia rearward to engage the fasteners.
  6. Install nut on fascia stud through the splash shield access hole, on each side.
  7. Install fasteners attaching fascia to the front fender and splash shield.
  8. Install grommet.
  9. Install the fasteners attaching the fascia to the lower crossmember.
scientia non olet · About LEMON Manuals