LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2000 >> Cirrus LXi, 2.0 C >> Repair and Diagnosis >> Engine Mechanical >> Cooling System (Mechanical) >> Engine Cooling System >> Radiator >> Installation

Engine Cooling System: Radiator: Installation

  1. Slide radiator and fan module down into position, seat the radiator assembly lower rubber isolators in the mount holes provided.
  2. Attach air conditioning condenser to radiator, if equipped. Tighten mounting screws to 5 N.m (45 in. lbs.).
  3. Install air conditioning line support bracket and attaching screw to right side of radiator.
  4. Connect engine block heater wire, if equipped.
  5. Connect lower radiator hose and clamp.
  6. Install external transmission oil cooler line support bracket and attaching screw to left side of radiator (if equipped).
  7. Connect automatic transmission hoses; tighten hose clamps to 2.5 N.m (22 in. lbs.).
  8. Install fan module.
  9. Connect fan motor electrical connection.
  10. Install upper radiator hose. Align hose so it does not interfere with the accessory drive belt or engine. Refer to COOLING SYSTEM SPECIFICATIONS & DRIVE BELT ROUTING . Position hose clamp so it will not interfere with the hood liner.
  11. Install upper radiator crossmember.
  12. Connect negative cable to auxiliary jumper terminal.
  13. Fill cooling system with coolant. Refer to COOLING SYSTEM SPECIFICATIONS & DRIVE BELT ROUTING .
  14. Operate engine until it reaches normal operating temperature. Check cooling system and automatic transmission for correct fluid levels.
scientia non olet · About LEMON Manuals