LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 1999 >> LHS >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Shift Interlock Systems >> Adjustments >> Shift Lock & Key Interlock Cables >> Concorde, Intrepid, LHS & 300M

Concorde, Intrepid, LHS & 300M

  1. On column shift applications, go to next step. On floor shift applications, go to step  3 .
  2. On column shift applications, if shift interlock does not operate properly, shift interlock cassette on steering column must be replaced. Shift interlock cable may only be adjusted once after installing NEW shift interlock cassette on steering column. See appropriate STEERING COLUMN SWITCHES article in ACCESSORIES & EQUIPMENT.
  3. On floor shift applications, apply parking brake. Place gear selector in Neutral. Remove set screw and gear selector knob. Remove ashtray located on center console bezel, below radio. Center console bezel fits around gear selector and on top of center console.
  4. Remove center console bezel-to-center console screw located just below ashtray area on center console bezel. Disengage clips holding each rear corner of center console bezel on center console. Remove center console bezel.
  5. Loosen shift interlock lever lock nut. See Fig 1 . Turn ignition on. Remove shift interlock cable from retaining bracket on gear selector assembly. Slide end of shift interlock cable from groove in interlock lever. See Fig 1 .
  6. Operation of shift interlock cable should be checked. With ignition on, pull on end of shift interlock cable. Shift interlock cable should move freely and return to bottomed out position when released. If shift interlock cable operates correctly, go to next step. If shift interlock cable does not operate correctly, check for improperly installed or kinked shift interlock cable. Repair as necessary.
  7. Turn ignition off and remove key. Pull on end of shift interlock cable. Shift interlock cable should not move when pulling on end of cable. If shift interlock cable will not move, go to next step. If shift interlock cable will move, check for improperly installed or kinked shift interlock cable. Repair as necessary.
  8. Place gear selector in Park. Slide end of shift interlock cable in groove on interlock lever. Ensure end of shift interlock cable is fully seated in groove.
  9. Slide shift interlock cable into retaining bracket on gear selector assembly until cable snaps into place. Ensure gear selector is still in Park. Turn ignition off and remove key.
  10. Loosen shift interlock lever adjusting nut (if not previously loosened) and allow shift interlock cable to adjust to proper position. Shift interlock cable will automatically adjust when adjusting nut is loosened.
  11. Tighten shift interlock lever adjusting nut. To check for proper cable adjustment, ensure ignition is off. Ensure gear selector lever is locked in Park. If gear selector is locked in Park, go to next step. If gear selector is not locked in Park, readjust shift interlock cable.
  12. Turn ignition on. Place gear selector in Reverse and try to remove ignition key. If ignition key cannot be removed, go to next step. If ignition key can be removed, readjust shift interlock cable.
  13. Place gear selector in Park. Turn ignition off. Try to remove ignition key. If ignition key can be removed, shift interlock cable is properly adjusted. If ignition key cannot be removed, readjust shift interlock cable. Reinstall gear selector and center console bezel.
Fig 1: Identifying Shift Interlock Cable & Components (Concorde, Intrepid, LHS & 300M)
G97C03820Courtesy of CHRYSLER CORP.
scientia non olet · About LEMON Manuals